cPro
Marketplace
location
Go!
Sell/Post
 
 add a note 
Save
2001 Dodge Ram 1500
5.9L 360 V8
155,xxx miles , Extended cab short bed
2wd Rebuilt automatic Transmission @ 150,000. Full rebuild+ Transgo Shift Kit
Rearend was rebuilt by dealership @ 130,000
3.55 rear
Premium Linex bed liner over the rails
Front windows tinted to match rear
Tan Heated Leather interior
Fresh color matched dash cap
No rips or tears in leather or carpet
New Heater core and blend door actuator fall of 17'
265/75/R16 BF Goodrich K02 tires 80%
New Grill with Billet inserts
New LED headlights/taillights/ foglight bulbs and assemblies
Sony Bluetooth Radio and door speakers, have factory radio too

I have a ton of work done under the hood and it was all done around 150,xxx right after new trans was put in.

Volant Cold Air Box
52mm Ported throttle body
New Mopar Iac, map, and tps sensors
New Mopar camshaft position sensor
Tune up cap, rotor, 8.5mm plug wires and autolite plugs, msd coil blaster
Gates belt tensioner, idle pulley, and belt
Hughes/Edelbrock Airgap Intake manifold
Billet Aluminum Fuel rails with braided crossover line
Mopar Magnum Aluminum Valve covers
Brand New EQ cylinder heads, stainless valves port matched to intake manifold had a shop go through the heads before install.
Heads are studded with ARP Head Studs
New pushrods and lifters
Harland Sharp 1.7 ratio Roller Rockers
Factory Cam
Comp Cams Double Roller Timing Chain Set
March Underdrive Crank Pulley
New water pump
New radiator and hoses
180* thermostat and new housing
Deleted mechanical fan on water pump and installed Flexalite E-fan
Stainless Short Tube Headers and brand new custom exhaust run all the way back. 2.25 in pipe ran into x pipe then ran through spintech mufflers
SCT Tuned

Truck sounds good but not too loud. I have a ton of extra stuff that goes with the truck. I've got an extra complete 360 engine. 2 pairs of heads, two factory intakes all kind of parts to build another engine.

I also have a blacked out grill for a 2nd gen Dodge that'll come with it. Bought an entire front end rebuild kit that includes upper and lower ball joints, tie rod ends, idler arm, pitman arm etc. Rough country steering Stabilizer. Bilstein front and rear shocks. 2 wheel bearing hub assemblies and 2 inch coil spacers to level the front end. These are all parts I've bought but haven't installed. Everything I have for this truck is coming with it.

3rd owner of truck a father and son both owned before me and it's been well taken care of and maintained. Bought a car for work and I just don't drive it enough. I have went out all winter and started the truck and let it run and took it down the road at least once a week so I don't let it sit.
$8500 really looking for cash but will also consider cash and things that go boom. Contact information 7652657331 I'll take calls, text or email anytime. If I don't answer I will try and get back with you within a day.
Brookville, IN
39 days ago
Seller's other items
Terms of Use  ·  Privacy Policy  ·  Support  ·  © cPro Marketplace